Hello Roadrunner2101. We regret learning of the difficulties you encounter with your pressure washer. Please find below a list of troubleshooting suggestions for your consideration. Clean Obstructed Nozzles: To clean the nozzles, soak all your nozzles in a half and half mixture of warm water and white vinegar. Soak all the nozzles for about an hour and then proceed to poke your nozzle cleaning tool or paper clip through the end of the nozzle hole to poke out any debris. After you have done this, rinse them with warm water. Your nozzles will now be free of any obstructions causing the unit to fail to function normally. Removing Air from The Line / Bleeding Out the Unit: Purge any excess air from the pump. Set up the unit as usual and ensure you are not using an extension cord. Remove any nozzle that may be connected at the end of the wand. Make sure that you have a green light on the GFCI on the power cord. Turn your garden hose on but leave the pressure washer turned OFF. With the pressure washer turned off, squeeze on the trigger for about 3 minutes – allowing the water to run through the unit at no pressure. In doing so, you are bleeding the unit out of any air that may be stuck in the pump. After 3 minutes, turn the unit on. If it is running, reinstall one of your clean nozzles and continue using the unit. Lastly, ensure the water source is fully opened and is at least 45PSI. There should be 10' of unrestricted garden hose between the hose connection and the unit, any kinks will prevent the flow of water going into the unit and prevent proper pressure. Please note this product has a three-year warranty from the date of purchase. If you have exhausted all troubleshooting steps and the problem persists, contact us through Live Chat on Greenworks Tools website or call 1-888-909-6757 (1-888-90WORKS). So, our experts can discuss your experience; please have your pressure washer with you along with the model and serial number to complete troubleshooting to ensure quick resolution is provided.