This is a good looking and sturdy chair but I have found after sitting for a couple of hours that it could use more cushioning on the seat as it goes a bit hard and flat. HOWEVER don't buy this chair if you are not mechanically inclined and don't own a set of drill bits as the threaded inserts in the seat bottom and back are not precisely aligned with the hole spacing in the arms - thus preventing assembly unless you drill out the holes in the arms to allow for the misalignment. Also the locking material applied to the threads of the supplied screws makes rotating the screws with the provided Allen wrench nearly impossible. I was only able to fully tighten the screws using a power drill fitted with a 5mm Allen driver.
Great chair. during assembly it was evident that one of the captured female threaded fasteners was not on axis. Work out fine but factory tolerances need to be checked.
I like the chair minus the fact that the arm rests level do not go up or down just up so you dont have an arm rest but it is very comfortable and am pleased with it . I would recommend the chair but just that item I have stated
Very comfortable. Love being able to raise and lower arms lower for support while working at my desk and raised when finished so that chair can slide under my desk.