1. Plug the power supply into the wall and the other end of the power supply into the little round hole in the back base of the antennae.
2. Next take the cable that runs from the back of the antennae that looks like it screws onto a cable tv box and connect it to the antennae input on your tv. If you can't figure this part out, just remember that the round spot with a hole in the middle is where you should be connecting the cable from the antennae.
3. Go into the tv settings, choose setup, then tell the tv to scan for new channels. This could take up to 10 -1 2 minutes.
4. Once the t.v. says it is done, you should be ready to view local channels.
Hope this helps.