Customer reviews from geappliances.com
GE - 3/4 HP Continuous Feed Garbage Disposer - Black
Average customer rating
4.4
(233 Reviews)
Rating breakdown 233 reviews
5 Stars
145
4 Stars
59
3 Stars
12
2 Stars
10
1 Star
7
90%of customers recommend this product.
(
199 out of
220)
Customer Reviews for GE - 3/4 HP Continuous Feed Garbage Disposer - Black
Customer Rating
5
Great Disposal
on July 11, 2020
Posted by: sashba69
from Kokomo, IN
Works great! No problems! This is just to meet GE min character count.
I would recommend this to a friend!
Features
5
Performance
5
Quality
5
Value
5
Written by a customer while visiting geappliances.com
Customer Rating
1
This product was very difficult to install.
on July 23, 2012
Posted by: Tiredandfrustrated
from Milwaukee, WI
The mounting system requiring the disposer to be held in place while the locking collar is twisted was very difficult. I tried numerous time both by myself and with an assistant but could not get the locking collar started. I finally used a jack to hold the disposer in place while turning the locking collar. Then trying to turn the collar far enough to fully lock the disposer in place was very difficult, even with the suggested petroleum jelly. There was no good way to get enough leverage on the ring because the small tabs only stick out about an inch. Next time I'll buy another brand.
No, I would not recommend this to a friend.
Written by a customer while visiting geappliances.com
Customer Rating
4
This product works well and is efficient
on October 5, 2012
Posted by: CB0123
from CB0123
[This review was collected as part of a promotion.] Like to ease of use. High quality components. Everything you could want in a disposall
I would recommend this to a friend!
Performance
4
Quality
4
Features
3
Value
4
Written by a customer while visiting geappliances.com
Customer Rating
5
excellemnt good value
on October 20, 2012
Posted by: Tom125
from Michigan, USA
[This review was collected as part of a promotion.] Cumbersome to install. Quite. Good instructions. I like it.
I would recommend this to a friend!
Performance
5
Quality
5
Features
5
Value
5
Written by a customer while visiting geappliances.com
Customer Rating
5
2700 rpm and quiet operation with stainless steel parts
on October 28, 2012
Posted by: Ed44
from St Augustine, FL, USA
Installation was trickier than expected. Got it right the second time!
I would recommend this to a friend!
Performance
5
Quality
5
Features
5
Value
4
Written by a customer while visiting geappliances.com
Customer Rating
4
A great Disposal that could use a few tweaks
on December 20, 2015
Posted by: Captainwingfoot
from Charlotte, NC, United States
I just finished installing what I believe will be a really great Strong disposal. It could use a few improvements in the installation area that would be a tremendous benefit. First, the dishwasher inlet port knock out plug is grossly under scored. It takes too muck force to knock the plug out as the instructions indicate. I used several "blunt" drifts finally relying on a 3/8 sucked extension after splintering two wooden dowel rods. When the extension finally breached the plug, I was rewarded with a badly bruised thumb. This plug, unless redesigned, should be drilled out and not knocked out. Second, I found the electrical connection box on the bottom of the unit has very limited access for the power cable. Two ports 180 degrees apart would help greatly. Thirdly, putting three cover back in place after making the electrical connections is way too difficult when you consider the bottom of most cabinets only gives you about 4 inches of clearance between the bottom of the unit and the cabinet floor. Also the nut that secures the round cover plate on the connection box cannot be tightened with either a nut driver or a thin wall socket. There is not enough clearance in the recess to allow the nut to be wrenched properly. You really should suggest in the instructions that the electrical connections be made with the unit upside down leaving a 3 or 4 ft length of cable as a pig tale for final connection at a close power access point. A final suggestion: the neck of the flange that passes through the sink bottom could be 2 inches shorter. This would provide adequate room for the assembly of all the mounting parts plus it would give much needed access area under the bottom of the unit to make the electrical connections. The time I spent for this installation that was a replacement of a broken disposal exceeded 6 hours. This included modifying the plumbing connections and major modifications to the electrical supply. A new installation would take less time. Having finally completed the installation, I am fully satisfied with the product and believe it will fully meet our expect ions.
I would recommend this to a friend!
Performance
5
Quality
5
Value
5
Written by a customer while visiting geappliances.com
Customer Rating
5
NICE UNIT
on November 28, 2019
Posted by: Anonymous
from WILTON MANORS FL.
THIS UNIT WAS VERY EASY TO INSTALL .FROM REMOVAL TO RUNNING IN ABOUT 30 MIN . I REALLY LIKE THE NEW GASKET FOR THE STAINLESS STEEL SINK . NO MESSY PLUMBERS PUTTY NEEDED. FLANGE WAS TIGHT BUT AFTER A LITTLE DISH SOAP WENT IN EASY . I'VE HAD A LOT OF GE APPLIANCES OVER THE YEARS .HOPE THIS ONE LASTS AS LONG AS THE OTHERS ..
I would recommend this to a friend!
Features
5
Performance
5
Quality
5
Value
5
Written by a customer while visiting geappliances.com
Customer Rating
4
Too early to decide
on March 12, 2021
Posted by: Lopoka
from Honolulu, HI
Though I thought the instructions were clear, my plumber had trouble with the sink flange and found the easy mount was not that that easy to actually mount. The product is much quieter than the decade old Kenmore and makes short work of small scraps. Makes an odd high pitch sound when it is about done, but seems OK.
I would recommend this to a friend!
Features
3
Performance
4
Quality
4
Value
4
Written by a customer while visiting geappliances.com