Customer reviews from mount-it.com
Mount-It! - Single Monitor Gas Spring Desk Mount for Up to 32 Screens Full Motion Ergonomic Arm - Silver
Average customer rating
4.8 out of 5
4.8
(29 Reviews)
Open Ratings Snapshot
Rating breakdown 29 reviews
5 Stars
24
4 Stars
4
3 Stars
1
2 Stars
0
1 Star
0
100%of customers recommend this product. 
(
4 out of 4
)
Best Buy Privacy Policy
Customer Reviews for Mount-It! - Single Monitor Gas Spring Desk Mount for Up to 32 Screens Full Motion Ergonomic Arm - Silver
Customer Rating
5 out of 5
5
works well for 34" ultra wide LG screen
on December 31, 2017
Posted by: H. Zhong
Works well with my 34" LG extra wide screen. was a bit a pain to install given the weight of everything (and it took a while to get all the tension screws right). Don't give up on it. it works :) . I found it best to tighten the screws before mounting the screen. The LG screens do not always come with the right adapter.
Written by a customer while visiting mount-it.com
Customer Rating
5 out of 5
5
Solid Monitor Arm
on December 23, 2017
Posted by: David T. Kreal
I've had the Mount-It! dual arm mount for quite some time, but I decided I wanted to go in a slightly different direction as the one downside to the dual mount system is an inability to adequately line up monitors with different bezel sizes to my liking. This is no fault of the previous mount, just me being a bit mildly OCD about getting my screens lined up. I also figure to be adding screens in the future so I wanted to try and find something that was a bit more flexible. I put this up against the Vivo single arm mount to see if one was better and this one is pretty good.It's easy to put together and easy to install a monitor to it. Rather than try to attach the monitor to the VESA mount while attached to the arm, this one has you attach the mount to the monitor, then slide it into a retention clip on the end of the mount. This makes placing and removing the monitor extremely easy if you need to make any adjustments to the actual monitor arm on your desk. The whole arm feels very sturdy, much more than the Vivo did and is able to hold much larger and heavier displays. It can hold up to 32" monitors, including ultra wide monitors as long as the weight doesn't exceed 20lbs.In the weeks since installing this arm, there has been no sag at all. The only issue I've encountered is there's a fair amount of shaking when even just typing, although I attribute this more to the desk not have a ton of support in the front. Either way, it's there and it's noticeable, particularly during extended typing sequences like this. So far that's the only drawback that I've encountered and again, could just be the desk.Overall, it feels very solid, holds my 24" AOC monitor up with no issues, and is definitely worth the price you pay for it.
Written by a customer while visiting mount-it.com
Customer Rating
4 out of 5
4
Great arm for 34 widescreen under 20lbs just purchase skinny cables
on December 15, 2017
Posted by: Nathan
So I purchased this as it was recommended for my new toy...dell u3415w. Installation was easy enough, I routed my cables and then mounted the monitor. When I first mounted the monitor, it appeared that the mount was unable to support the 19.5 lb monitor...then I figured out you had to loosen the nut to stiffen the arm. That resolved that. Then because I am a bit OCD with my cable routing, I ran the cables through the channel in the arm...that was a bit of a challenge as I purchased well shielded cables. I ended up purchasing longer cables, both power and DP to make the longer run. In the process of changing out cables I broke 1 of each of the cable routing clips. That being said, I would recommend purchasing thin cables for easier routing. I have yet to co tact the manufacturer to see if they will replace the clips as they just screw in. Besides that, I really like the arm. It is easy to manipulate and move the monitor. If the clips were maybe rubber rather than plastic, I would give it a 5/5 rating.
Written by a customer while visiting mount-it.com
Customer Rating
5 out of 5
5
i have two of these and it was the best idea yet for my monitors
on October 8, 2017
Posted by: Adrian Ward
i have two of these and it was the best idea yet for my monitors. I bought two singles because i have ultrawide monitors and i am still able to set these up so that my monitors are stacked but adjustable which my stand couldn't do for me.
Written by a customer while visiting mount-it.com
Customer Rating
5 out of 5
5
Great for heavy ultrawides
on October 7, 2017
Posted by: Mike
Holds my 35\ Ultrawide monitor (Acer Z35P) with ease."
Written by a customer while visiting mount-it.com
Customer Rating
5 out of 5
5
Works like a charm.
on September 30, 2017
Posted by: Keith Goreham
It's holding up a monitor that I use for running 3D printers.
Written by a customer while visiting mount-it.com
Customer Rating
5 out of 5
5
This is a great monitor arm stand by Mount-It
on September 26, 2017
Posted by: Janey Luu
This is a great monitor arm stand by Mount-It! This monitor desk mount or computer monitor stand has a height adjustable arm that fits up to 32 Inch Screens and up to 20 Lb Capacity.I have a Samsung C32HG70 32-Inch HDR QLED Curved Gaming Monitor and this monitor arm stand can support this with ease. You have to read the manual to adjust the arm to able to support the monitor.
Written by a customer while visiting mount-it.com
Customer Rating
3 out of 5
3
I like how this mount adjusts and the tension on the ...
on September 19, 2017
Posted by: MaverickSY19
I like how this mount adjusts and the tension on the arm is great. Has no problems with my monitor, but I give it 3 stars because the bracket that holds the monitor to the arm and controls the up and down tilt has to be tightened with an Allen wrench and it does a poor job of holding up my 19lb 32inch monitor. I think it could use better bracket some teeth or something to keep it from slipping. I had to basically tilt my monitor up more than I wanted by a lot, tighten the thing until I thought I was going to break the wrench then let it nose down from there until it tightened up more from the weight and held. Seems OK now but I don't ever want to have to adjust that tilt again its just not very workable.
Written by a customer while visiting mount-it.com
Showing 17-24 of 29 results 
<< 1 2 3 4 >>