Easy start up on first operation! Put oil in that was supplied, soft pulled the pull cord and then started it right up. I’m still in the break in period but so far it’s going smoothly
Just picked up this generator yesterday. It's the perfect sized unit to provide backup power for our 24' Travel Trailer. It's powerful enough to run the A/C and microwave or coffee pot, yet light enough to load in the back of the truck singlehandedly (60lbs). It also fits under my BakFlip MX4 bed cover with a 1/2" to spare.
Received this iGen4000DFcv Inverter Generator today. Did the unpackaging, read all of the instructions. Filled with oil. My intension is to run the genset on propane only as I want to store it in a safe place without gasoline fumes and draining and Stable, etc. Had the unit outside, propane tank connected to genset, ECO mode off, Switch on, choke on. Pulled several times and nothing, tried the chock at 1/2 position, off position, back to on position. After 50 pulls, Stopped. Decided to hold the propane tank upside down for a few seconds. Pulled a few more times and it finally started. Ran well. Let warm up for 15 to 20 minutes in bot the ECO and off modes. Shut the unit down. Propane still on. Came back 5 minutes later and tried starting again, same results more than 40 pulls and nothing. Finally, had to pull the side cover and the cover off the filter and resort to a shot of starting fluid into the breather opening. Unit finally started. Ran Ok again. I am disappointed in that I would expect this unit to start "significantly" easier than this exercise demonstrated. Especially for a brand new unit. It was 55F outside, so not cold. I can't imagine trying trying to start this unit when its 5F outside and you really need it. I hope it gets better or I can find a way to get it to start better than it does. The engineering in this aspect leaves alot to be desired, especially for the cost.
No, I would not recommend this to a friend.
Response from westinghouse.comBy eComm, May 11, 2026
Hello, thank you for letting us know about this. We are genuinely sorry to hear about it. I have passed your feedback along to our quality control team to ensure that we are producing the best units possible. Please contact us at 1-855-944-3571 or support@wpowereq.com and we will look into the matter.