Just received my generator after adding oil and gas started on second pull. Much quieter than others I've used. Bought it for back-up power for hurricane season so I haven't had the opportunity to use it.
Right out of the box I could sense the ease, comfort and reliability of this Gen. Set. I will be powering a 1 H.P. Evap cooler motor (Using the L5-30) protected, in series with a (pop up / push to reset), as a 20 A circuit. The (evap) motor ( on low speed ) draws 3.5 RLA and has a LRC of 17A. The 20A O.L. protection that I engineered, held thru the start (LRC) sequence, and the wGen3600 barely grunted to meet the needs. The other (5-20R) will host loads such as Floor (circ) fans and house lighting. The combined load(s) onto this receptacle will be (roughly) 6.8 A. Once initiated into service during a utility outage (start up and transferred) I will use the Evap's 'snap toggle' to switch it onto hi speed. Hi speed on said device has a RLA value of 10.3 Performed the sequence and load test to the wGen3600 right after the wheel and feet assembly and gas and oil added. Very pleased with the wGen3600. Las Vegas can get hot. It's like a desert out here :) and utility outages occur most often: end of May and entire June and throughout July and Aug as well. I feel at ease knowing that this Evap and circ fans are on a 'hot stand by' knowing I have a dependable generating station