Customer Reviews for Arrow - T25 Low Voltage Wire Staple Gun
Customer Rating
5
Stapler worked great for securing speaker wires.
on August 29, 2018
Posted by: Patti60
from Hobson, Texas
Gender:Female
[This review was collected as part of a promotion.] This stapler worked great securing speaker wires overhead for the church we are rewiring. Got the job done quick and easy.
[This review was collected as part of a promotion.] Works great for securing low voltage cable most of the time. Will jam sometimes for no apparent reason.
[This review was collected as part of a promotion.] I bought this rounded top stapler for a small upholstery project. It worked great for my needs and I'm looking forward to using it for future small wire projects.
Pros: Crafting, General Repairs, insulation, Upholstery, Wiring
[This review was collected as part of a promotion.] I've worked in the low voltage industry for over 10 years and this is the only stapler I would recommend. Works good in corners and is accurate.
[This review was collected as part of a promotion.] Used to run camera wiring and CAT5, never hits the wire, puts down the right amount of pressure to hold without too much pressure.
I installed two new garage door openers. Since they're jackshaft openers and replaced standard garage door openers, nearly all of my wiring had to be rerun and I needed to tack all of the new wires to the ceiling and walls of my garage. I borrowed my neighbors 20+-year-old T-25M, but when I ran out of staples, I decided to go to the hardware store and just buy my own T25P, along with some more T25 staples. I mounted both wall controls side-by-side near the door into the house and ran 4-wire sprinkler cable to the front of the garage, then split the two-wire pairs and spliced in regular two-wire bell wire to run to each side of the garage where the openers are mounted. It worked great stapling the 4-wire cable across the ceiling of the garage as well as the two-wire bell wire across the front of the garage above the springs.