Customer reviews from arrowfastener.com
Arrow - T50ACD Compact Electric Staple Gun
Average customer rating
4.7
(17,940 Reviews)
Rating breakdown 17,940 reviews
5 Stars
14,065
4 Stars
3,387
3 Stars
310
2 Stars
71
1 Star
107
98%of customers recommend this product.
(
17,254 out of
17,524)
Customer Reviews for Arrow - T50ACD Compact Electric Staple Gun
Customer Rating
3
recover dining room chair cushions
on July 27, 2024
Posted by: Capt
from Florida
Gender:Male
[This review was collected as part of a promotion.] arrow T50ACD forced me to use 1/4 inch staples. Seat backing material maybe dense masonite type material. some penetration failure. Staples bending. Overall still seemed to do the job.
Pros: General Repairs, Upholstery
I would recommend this to a friend!
Response from arrowfastener.comBy Arrow Fastener Customer Service, July 29, 2024
Hello -
It's always advisable to check the suggested staple length before beginning an application. Here's a link to our staple guide for more information: https://bit.ly/3fJdrRS.
Here's a link to the manual for your staple gun: https://bit.ly/t50acd-manual.
Hope this information is helpful!
- Your Arrow Fastener Team
It's always advisable to check the suggested staple length before beginning an application. Here's a link to our staple guide for more information: https://bit.ly/3fJdrRS.
Here's a link to the manual for your staple gun: https://bit.ly/t50acd-manual.
Hope this information is helpful!
- Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com
Customer Rating
1
Does NOT support upholstery work as stated
on August 8, 2024
Posted by: TheExpert
from Plano, TX
Gender:Male
[This review was collected as part of a promotion.] News Flash. Most furniture is made from hardwoods. This staple gun only drives 3/8" staples halfway into oakand then severely bends them so they can't even be hammered. (And yes, I was using T50 Arrow staples)
Very disappointing about the product and the misleading product description. It creates more re-work by using it.
Very disappointing about the product and the misleading product description. It creates more re-work by using it.
Pros: Upholstery
No, I would not recommend this to a friend.
Response from arrowfastener.comBy Arrow Fastener Customer Service, August 14, 2024
Hello -
We're sorry to hear that you're unhappy with your staple gun. Please review the manual for complete operating instructions and troubleshooting help. Here's a link: https://bit.ly/t50acd-manual. We recommend placing a hand on top of the stapler when firing for maximum force.
- Your Arrow Fastener Team
We're sorry to hear that you're unhappy with your staple gun. Please review the manual for complete operating instructions and troubleshooting help. Here's a link: https://bit.ly/t50acd-manual. We recommend placing a hand on top of the stapler when firing for maximum force.
- Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com
Customer Rating
5
Reupholstering Dining Room Chairs
on August 25, 2024
Posted by: Jjacks
from Dallas, TX
Gender:Female
[This review was collected as part of a promotion.] The PowerShot Compact Electric Staple Gun was the perfect tool for reupholstering our dining room chairs. We used ¼ inch and 1/2 inch staples. We were stapling into MDF and had no problem getting the staples to penetrate. Using an electric staple gun made getting the fabric tight on the seat easy and I was able to do it without any assistance. Our chairs look like new!!!
Pros: Crafting, General Repairs, Upholstery
I would recommend this to a friend!
Written by a customer while visiting arrowfastener.com
Customer Rating
3
Works well when it works
on October 5, 2024
Posted by: Pajama
from Houston, TX
I bought this stapler and used it for a project and it worked very well. A couple of months later, i took it out to use again and it would not work at all. Took it back to the store and got another one. If this one does the same, I will look for something different.
Pros: Crafting, Upholstery
Response from arrowfastener.comBy Arrow Fastener Customer Service, October 10, 2024
Hello - Thank you for sharing your experience with our Customer Service team. We really appreciate it!
We strive to provide quality products and service to all of our customers. We're happy that you received the service you deserve and hope your new staple gun works well for you. - Your Arrow Fastener Team
We strive to provide quality products and service to all of our customers. We're happy that you received the service you deserve and hope your new staple gun works well for you. - Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com
Customer Rating
3
Not appropriate for my use, not enough driving power.
on December 2, 2024
Posted by: GSV9055
from Boston, MA
Gender:Male
[This review was collected as part of a promotion.] I was using T50 3/8 inch staples to secure an electric cable for holdiay lights to a fascia board. The staples would pull or fall out with minimal tension. The staple was shot from the electrical cord, so the nose of the gun was not flush with the fascia board. Regardless, the staple did not penetrate the board and it was difficult to disengage the safety by keeping the nose centered on the electrical wire. I prefer a slide safety lever instead of the nose release.
Pros: General Repairs, Wiring
No, I would not recommend this to a friend.
Response from arrowfastener.comBy Arrow Fastener Customer Service, December 9, 2024
Hello -
Here is a link to the manual for this tool where you'll find information that might help: https://bit.ly/t50acd-manual. Also take a look at our staple guide: https://bit.ly/3fJdrRS. You might be using staples that are too long for the application.
- Your Arrow Fastener Team
Here is a link to the manual for this tool where you'll find information that might help: https://bit.ly/t50acd-manual. Also take a look at our staple guide: https://bit.ly/3fJdrRS. You might be using staples that are too long for the application.
- Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com
Customer Rating
3
May be good for balsa wood
on December 19, 2024
Posted by: Jack2024
from San Diego
Gender:Male
Half of my 1/4in staples never went in straight. Had to push down, to staple screen into pine frame. The tool did not do the work.
Pros: General Repairs
No, I would not recommend this to a friend.
Response from arrowfastener.comBy Arrow Fastener Customer Service, December 23, 2024
Hello -
We're sorry to hear that your staple gun didn't work well for you. Here's a link to the manual, which includes instructions and troubleshooting help: https://bit.ly/t50acd-manual.
- Your Arrow Fastener Team
We're sorry to hear that your staple gun didn't work well for you. Here's a link to the manual, which includes instructions and troubleshooting help: https://bit.ly/t50acd-manual.
- Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com
Customer Rating
3
Product works well but, instruction manual is nut usefull
on January 10, 2025
Posted by: Popdude
from Mount Pleasant, WI
Gender:Male
This product works well and is ergonomically comfortable to operate. The instruction manual leaves much to be desired. For starters the print is very small for an older person to read. the diagrams are even worse and poorly illustrated. Had I not used an electric stapler previously, I would probably not have gotten it loaded with staples. A better manual would have gotten a better rating.
Pros: Crafting, Flooring, General Repairs, insulation, Upholstery
No, I would not recommend this to a friend.
Response from arrowfastener.comBy Arrow Fastener Customer Service, January 31, 2025
Hello - We have videos for the T50ACD staple gun on our website and on YouTube. This is an overview of the features of the tool: https://bit.ly/36cypoi.
We appreciate your review! - Your Arrow Team
We appreciate your review! - Your Arrow Team
Written by a customer while visiting arrowfastener.com
Customer Rating
3
Not as forceful pushing in the staples.
on January 27, 2025
Posted by: Janis629
from North Carolina
Gender:Female
This product has a safety feature and can only be used when the contact safety is pressed. I wanted to use it in covering my dining room chairs however half of the time this safety feature slipped causing the staples to go in wonky and I had to pull these out and try to staple again. This may have to do with the force with which the staple goes in.
Pros: Upholstery
Response from arrowfastener.comBy Arrow Fastener Customer Service, February 4, 2025
Hello -
Be sure you press the contact safety firmly against the surface before firing. You also may want to try using shorter staples. You'll find complete operating instructions in the manual: https://bit.ly/t50acd-manual.
- Your Arrow Fastener Team
Be sure you press the contact safety firmly against the surface before firing. You also may want to try using shorter staples. You'll find complete operating instructions in the manual: https://bit.ly/t50acd-manual.
- Your Arrow Fastener Team
Written by a customer while visiting arrowfastener.com