Customer Reviews for Mount-It! - Freestanding Triple Monitor Desk Stand for 1927 Screens with Height, Tilt, Swivel & Cable Management - Black
Customer Rating
5
Its pretty good
on July 13, 2018
Posted by: Pavel
Exactly what I needed, very good quality build parts, it let's you adjust the screens with many angle approaches, it even has a height adjustment for every screen mount so if your screens have a height difference due to a bigger frame or mount point you can adjust them all still to be the same height ( gives you an inch +/- of margin to play with) - not that common on these products.Note that if you plan not to attach the center pole to the table and simply place it as is with the base plate, you will limit yourself to the angle of how much you can turn the side monitors curved to your direction since the center-weight-point will be moved further then the base playe and it will fall forward. In my pictures you can see the maximum angle to curve without mounting the pole to the table
Written by a customer while visiting mount-it.com
Customer Rating
3
It would not stand up using the supplied base with ...
on February 3, 2018
Posted by: Customer
It would not stand up using the supplied base with 2 monitors. I drilled a hole in the desk and mounted it with the hardware and that worked great
Written by a customer while visiting mount-it.com
Customer Rating
3
Three Stars
on March 21, 2018
Posted by: Ryan
The mount keeps falling back down after tightening the vertical tilt bolts.
Written by a customer while visiting mount-it.com
Customer Rating
3
Works great but don't break your monitors during setup
on April 9, 2018
Posted by: Nicholas N.
Once you get it all setup it works great and is sturdy. Reason for 3 stars is setup was a nightmare. As you mount each monitor, the thing just wants to fall over until all 3 are mounted and it was a huge pain. Other than that, great product.
Written by a customer while visiting mount-it.com
Customer Rating
3
It might get the job done, but expect hassle and compromise.
on April 12, 2018
Posted by: Anthony Hammen
I bought the triple mount for 2x Acer S231HL and 1x Acer KG240. The instructions were clear and the mount was packaged well, but that was about it. The grub screw to prevent the center monitor from angling is impossible to reach. It cannot support the weight of the three monitors listed above, at least not in any fashion I had wanted -- I currently have one in portrait and, while it gets the job done, it's not preferred. If I tried to lay that monitor in landscape and angle it towards me, all three would come crashing down.
Written by a customer while visiting mount-it.com
Customer Rating
3
Almost good enough to buy again.
on April 20, 2018
Posted by: Joshua C.
Build quality overall was pretty good however, tolerances were an issue for me because the monitors did not sit exactly square and straight.
Written by a customer while visiting mount-it.com
Customer Rating
3
This mount i don't like that much
on June 28, 2018
Posted by: hector r. argotte
This mount i don't like that much, cuz monitors don't align properly and they hit each other if u try to angle them towards you...
Written by a customer while visiting mount-it.com
Customer Rating
3
Works fine with the stand, but not desk mounted
on July 10, 2018
Posted by: Nate
Overall the build quality is ok. The plastic cable management loops broke almost immediately, not a big deal. The hex joints on the arms don't stay completely stationary when tightened down fully, also not a huge deal.If you're planning on mounting straight to a desk so that you don't have to use the bulky stand, this isn't your stand. The weight of the monitors causes the stand to lean forward quite a bit and it can't be screwed any tighter without damaging the wood desk it's mounted to.Also it was nice of them to include the thumbscrews for mounting the monitors but I wouldn't trust the plastic on them of you have expensive monitors.