Customer reviews from Creality
Creality - Space Pi X4 Dryer - Space Gray
Average customer rating
4.3
(20 Reviews)
Rating breakdown 20 reviews
5 Stars
13
4 Stars
3
3 Stars
2
2 Stars
0
1 Star
2
Customer Reviews for Creality - Space Pi X4 Dryer - Space Gray
Customer Rating
4
I like the dryer..but
on August 3, 2025
Posted by: Eusebio
I like the dryer...
but, the temperature is way off by 15-20degf over.
It controls well but displays the wrong temp.
but, the temperature is way off by 15-20degf over.
It controls well but displays the wrong temp.
Written by a customer while visiting Creality
Customer Rating
3
good overall with some small gripes...
on June 15, 2025
Posted by: Troy
I like the dryer, it gets the job done, but I am not a huge fan of the touch screen interface. Sometimes it takes several presses to work correctly and seems slow.
Other than that, it gets the job done and I am happy with it
Written by a customer while visiting Creality
Customer Rating
1
Broke down after first use
on June 1, 2025
Posted by: CO
Keeps flashing E4? Which I think means the heater is broken. Used one time.
Written by a customer while visiting Creality
Customer Rating
1
Regularly repeating E4 error code, stops heating.
on May 17, 2025
Posted by: hallgrouch
At first it was working wonderfully. Now about 2 weeks into trying to use it regularly after 20 minutes or so of operation it starts flashing E4 error code and stops heating. Sounds like fan still runs. I tried doing the recommended full power shut off but the problem keeps returning over and over.
Written by a customer while visiting Creality
Customer Rating
5
on May 15, 2025
Posted by: Dawson
Pretty easy to use, simple and good looking design.
Written by a customer while visiting Creality
Customer Rating
4
Seems decent
on April 30, 2025
Posted by: Austin
I really wish it did more for the price tag. Maybe some integration with my K1C would have been nice. It does get the humidity down to around 25% overnight but I feel the tubes should go out the back side instead of the top. It would be easier to link the system to my K1C. But if it used a separate extruder per filament, it would be nicer. I use this to actually print from as it seems to help a little by pre-heating the filament before entering the print head. Another feature that could be added is a way to merge the two filaments into a junction that could detect when one spool was empty, and it could automatically follow the filament with a new one. Could be something as simple a set of extruders that were set on pressure sensors. It could receive a signal from the printer to start the refill process and then use a pressure sensor on the extruder to tell when it is under pressure. That way it would know when to stop extruding and then restart once pressure is released.
Written by a customer while visiting Creality
Customer Rating
5
Creality Space Pi Filament dryer plus
on April 30, 2025
Posted by: Derrick
It is a good looking unit and it works wonderfully. One thing I could see to be useful would be to have an option to have the filament rolls rotate so that while the filaments are drying they don't get dryer on one side than the other.
Written by a customer while visiting Creality
Customer Rating
5
Great filament dryer
on April 18, 2025
Posted by: Joseph
I really wanted to wait for the new Space Pi 4 roll dryer, but needed to get a dryer now this one was available and very reasonable priced. So far it works well I would recommend it. I do wish that the door has some sort of rubber seal though.
Written by a customer while visiting Creality